Last seen: Dec 24, 2024
I remember I tried it several months ago and it was working but I don't remember if i did any special configs. Its most likely just a config issue. O...
Thanks for the suggestion. We will certainly consider it. the challenge with the current model is its reached it capacity for firmware size so adding ...
Hi. Are you using the quad plus with LCD screen? if so, do you see any movement on the screen as you try to use the trackball? please try each o...
Hi. interesting issue. The range the iCode quad reports to Linux is {-32767, 0, 32767) when the stick as setting on the device is set to Left or Ri...
Glad its back to working! Yes, the newer firmware is too large so there is no space for standard bootloader so the system will not see it as com port...
@galaxxian looks like the unit is in Genesis mode and paddles forced on in settings. Try this. Flash the normal H11907 firmware and press the ...
I see. And what is the issue when you tried the DuoPlusH11V907 ?
Hi. I assume you have the version where the there are two rows of 3 buttons? Try this firmware:
please try the manual process shown at the bottom of this page. under section: "Force Update without PROG – Command Line Only"
Hi. SteamDeck might be relying on Direct Input or xInput instead of standard HID for game controllers. Unfortunately, the device currently only suppo...
Hi there. thanks for the post. Unfortunately, no support for seg master system yet. I will probably add support for it in the near future with a fi...
Hi Thomas, The driving controller video is a bit out dated and i will have to make a new one. To get to the menu system, press RED and GREEN at sam...